It's definitely not the battery. When I plug in the USB cable to my laptop without the battery, the red light just flashes red. Inserting the battery, the green light comes on indefinitely until battery is completely drained.
I presume if I just plug in without the battery, it should be detected as a flash drive Correct me if I am wrong.
I have the exact same problem! Plugged in the USB cable and the green light comes on. It just continues draining the battery even after I unplug the power. I also tried using the original firmware which was saved in the original 4GB micro sd card but it doesn't help at all.
I think this is probably a hardware problem. Ordering a new piece to replace the dead one.
It's definitely not the battery. When I plug in the USB cable to my laptop without the battery, the red light just flashes red. Inserting the battery, the green light comes on indefinitely until battery is completely drained.
I presume if I just plug in without the battery, it should be detected as a flash drive Correct me if I am wrong.
Could be your battery change to new battery
I have the exact same problem! Plugged in the USB cable and the green light comes on. It just continues draining the battery even after I unplug the power. I also tried using the original firmware which was saved in the original 4GB micro sd card but it doesn't help at all.
I think this is probably a hardware problem. Ordering a new piece to replace the dead one.
but now screen cannot open.
OK,i will try Thanks a lot
You need to download the stock firmware here https://rs97.bitgala.xyz/04.%20os_images/Internal%20SD%20Card/rs97_2.0/Stock_shipped_firmware_v2.0.7z
extract the firmware and then write it to a 4gb formatted memory card using win32diskimager
then boot it.
how to reflash stock??
Reflash stock firmware it should still power with out the battery and try a different power source adapter.
press reset already but nothing happen,and cannot do anything
And try to reset the device the small reset pinhole on bottom right press it on the device.
Did you try to reflash and boot with the stock firmware again what version rs-97 do you have v2.0 or 2.1?
i put battery in have the lighting red but can not press anything also
Did you try with battery in?